How it works
Grout fills the joints between tiles, so the amount depends on how long the joints are, how wide they are and how deep they are. The depth is the tile thickness. For every square foot of floor there are joints along the length and the width of each tile, and the calculator adds up their volume.
The volume is turned into weight with a typical figure for cement grout: about 1.8 kilograms per litre of joint. An allowance is then added because some grout is wasted on the float, sponge and bucket. The default is 10%.
Bags are rounded up to whole bags. Epoxy grout and premixed grout are sold in other units and weigh a bit differently, so use this as a guide and check the coverage on the product label, which often gives the coverage for a given tile size and joint.
Check it by hand: for 12 in tiles there are 2 ft of joint in every square foot. A joint 1/8 in wide and 3/8 in deep has a cross-section of 0.046875 sq in, so a square foot needs 24 × 0.046875 = 1.125 cubic inches. For 100 sq ft that is 112.5 cubic inches, or 1.84 litres. At 1.8 kg per litre this is 3.32 kg, and 10% extra makes 3.65 kg, which is 8.05 lb.
Joint length per m² = 1 ÷ tile length + 1 ÷ tile width Grout volume per m² = joint length × joint width × tile thickness Weight = volume × 1.8 kg per litre × area × (1 + extra ÷ 100)
Worked example
A floor of 100 square feet with 12 inch tiles, 3/8 inch thick, and 1/8 inch joints holds 1.125 cubic inches of grout per square foot, which is 112.5 cubic inches in all, or about 1.84 litres.
At 1.8 kg per litre that is 3.3 kg (7.3 lb). With 10% extra you need about 8 lb, so one 10 lb bag is enough.
Good to know
- The figure is an estimate. Rough or uneven tile, deep bevels, textured stone and wide joints need more grout than a smooth tile with a thin joint.
- Grout weight changes with the brand and the water in the mix, so the bag count can be off by a bag on a large job. When in doubt, buy one extra bag of the same batch.
- Small mosaic sheets have many joints per square foot. Enter the size of one small tile, not the sheet, to get a sensible answer.
Questions people ask
How much grout do I need for 100 square feet of tile?
For 12 inch tiles that are 3/8 inch thick with 1/8 inch joints, about 8 pounds including 10% extra. Smaller tiles, thicker tiles or wider joints need more, so use the calculator with your own sizes.
Does a wider grout joint use much more grout?
Yes. Grout use is directly proportional to the joint width, so a 1/4 inch joint uses twice as much grout as a 1/8 inch joint with the same tile.
Sanded or unsanded grout?
Sanded grout is usually used for joints wider than 1/8 inch. Unsanded grout suits narrow joints and polished stone that sand could scratch. Both give a similar amount per area.
Why is my result different from the bag label?
Brands publish coverage for a particular tile size and joint, and they measure it differently. Compare like for like by entering the same tile size and joint as on the label.
How much grout do I need for 100 square feet of 12 inch tile?
About 8 lb with 10% extra, using a 1/8 inch joint and tiles 3/8 inch thick. One 10 lb bag covers it.
Part of the guide: Building material calculators: concrete, blocks, bricks, flooring and more